Three Ways To Deal With Non Circulating Cold Water Of Chiller

May 11, 2021

Leave a message

It must be noted that whether the cold centrifugal pump is built-in or external, it is proposed that the water level of the cold centrifugal pump should be lower than that of the cold water storage tank (pool). In that way, the circulating water pump can absorb the cold water very well. However, in individual cases, because of the necessity or limitation of the natural environment, the cooling water storage tank (pool) will make the cooling water circulating water pump higher than the water level of the water storage tank (pool). In that case, the cooling water system software often fails to absorb water during operation, For the common fault of insufficient total flow of cooling water in the industrial chiller, the chiller manufacturer can find out the reason in the common fault display information on the control panel of the industrial chiller:

Use the rubber hose to return the water from the cold water storage bucket (pool) to the embedded make-up water on the large pipe of the cold water circulating pump! The small pipe is filled with water (open its small gate valve), and the small pipe joint of the exhaust pipe of the cooling water circulating pump is twisted open with a handle (if there is water, then tighten it again), until the intelligent return water flows back to the large pipe of the cooling water storage tank (pool), and the rubber hose is pulled open, and no bubbles appear. If there are, please fill the water again until there are no bubbles and close the small gate valve again;

At this time, turn on the industrial water cooler for 1 ~ 3 minutes, if the large water flow returns to the pool, everything will be normal.

Nanjing RICOM Refrigeration Equipment Co.,Ltd is an industry-trade integrated manufacturers for 20 years,who is engaged in the industrial temperature control technology,implements the modern quality management system ISO9001:2008 and ISO14001 environment system:2004 standard,to ensure enterprise team in technology innovation,we pay attention to customers' sense of use and satisfaction, and get the consistent recognition of the industry and customers;obtained AAA credit rating certification.In 2016, it was awarded as a contract abiding and trustworthy enterprise.In 2013,the company established the production base of chiller and mould tempering machine in Chuzhou RICOM plastic technology Co.,Ltd.

In order to comprehensively improve the market competitiveness of the company,we made efforts with the United States “Copeland” company for technical cooperation,and imported a variety of new production equipment,from Europe,the United States,such as high quality materials,so that the product quality can be a strong guarantee!We can provide customers with more safety, precision, energy saving, environmental protection,cost-effective products and considerate after-sales service,products sold throughout the country,and exported to Arab,African,Russia,Vietnam,Malaysia and other southeast Asian countries and Europe and the United States.


Send Inquiry
Send Inquiry