1、 Outdoor air cooled chillers:
Because the average temperature in winter is low, and the generator set is running outdoors, when the generator set is just started in the morning, because the refrigerant in the refrigeration unit of the generator set has its own characteristics (high working pressure when the temperature is high, low working pressure when the temperature is low), so when the generator set is just started, the working pressure is very low, and even the low-pressure alarm will appear, especially for small generators Groups, such as models under 3HP, are more prone to such a situation.
Solution:
If it is very possible to move the generator set into the room as far as possible, the room temperature will be much higher than outdoor at least, and the average temperature will be maintained above 6 degrees, then most of this problem will not occur. However, the working pressure of small and medium-sized generator sets, such as 1-2hp, will be very low, and they will gradually increase for a period of time, and then they will just start to cool.
In most cases, it is impractical to move the generator. In that case, we can choose the way of forced generator start. Go to the main parameter adjustment of the control panel of the generator set, and set the "bottom pressure test delay" (detailed main parameter mode) in the time setting In this way, after 30-60 seconds of operation, the working pressure will gradually rise without bottom pressure alarm. In this way, the manufacturer does not recommend long-term application. Only when the bottom pressure alarm appears during ultra-low temperature start-up, it can be set like that and the temperature will rise High, there will not be such a problem, we have to change this main parameter home. In general, the manufacturer is not allowed to change the embedded main parameters, so it is not necessary to modify as much as possible.
If the air conditioner evaporator in the generator set is plate heat exchanger type or shell tube type, when it is shut down after work, the water in the flat plate or shell tube type air conditioner evaporator in the generator set should be drained out to prevent the internal water from freezing and cracking the air conditioner evaporator, and the more powerful way is to add a certain proportion of automobile antifreeze in the chilled water, which can also avoid such a difficult problem Problem, but in the long-term shutdown time, whether it is able to add car antifreeze, or it is best to drain out the water.
Outdoor placement and application of water cooler chiller:
Since the water cooler must be equipped with FRP cooling tower, and there is no doubt that the FRP cooling tower will be put outdoors. Naturally, for special applications or Regal applications, it is better to put the cooling tower in the room. Therefore, it is necessary to do the cold proof work of FRP cooling tower.
1. The cooling circulating water of FRP cooling tower plus a certain proportion of automobile antifreeze generally accounts for about 20%. According to different well-known brands, models and specifications of automobile antifreeze are different. In the case of long-term shutdown, drain the water.
2. If the air-conditioning evaporator in the generator set is plate heat exchanger type or shell tube type, when it is shut down after work, the water in the flat plate or shell tube type air-conditioning evaporator in the generator set should be drained out, so as to prevent the internal water from freezing and cracking the air-conditioning evaporator It is to add a certain proportion of automobile antifreeze to the refrigerated water, which can also avoid such problems. However, in the long-term shutdown time, whether it is possible to add automobile antifreeze or not, it is better to drain the water.
Nanjing RICOM Refrigeration Equipment Co.,Ltd is an industry-trade integrated manufacturers for 20 years,who is engaged in the industrial temperature control technology,implements the modern quality management system ISO9001:2008 and ISO14001 environment system:2004 standard,to ensure enterprise team in technology innovation,we pay attention to customers' sense of use and satisfaction, and get the consistent recognition of the industry and customers;obtained AAA credit rating certification.In 2016, it was awarded as a contract abiding and trustworthy enterprise.In 2013,the company established the production base of chiller and mould tempering machine in Chuzhou RICOM plastic technology Co.,Ltd.

